Jeep Wrangler 2018-2025 Owners Manual / GETTING TO KNOW YOUR VEHICLE / CLIMATE CONTROLS
Jeep Wrangler: GETTING TO KNOW YOUR VEHICLE / CLIMATE CONTROLS
The Climate Control system allows you to regulate the temperature, air flow, and direction of air circulating throughout the vehicle. The controls are located on the touchscreen (if equipped) and on the instrument panel below the radio.
- Automatic Climate Control Descriptions And Functions
- Manual Climate Control Descriptions And Functions
- Automatic Temperature Control (ATC) — If Equipped
- Climate Voice Commands
- Operating Tips
Rear Window Wiper/Washer — If Equipped
A rotary switch on the center portion of the
windshield wiper/washer lever controls the
operation of the rear wiper/washer function.
Rear Wiper/Washer Control
Rotate the switch upward to the
first
detent position for intermittent
operation and to the second detent
for continuous rear wiper operation...
Other information:
Jeep Wrangler 2018-2025 Owners Manual: LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they are replaced as an assembly. Rear Tail, Stop, Turn Signal, And Backup Lamp See below steps to replace: Remove interior trim panel cap to access single retaining screw for tail lamp assembly. Trim Cap Remove retaining screw and disconnect electrical connector, then remove tail lamp assembly from the vehicle...
Jeep Wrangler 2018-2025 Owners Manual: Tire Pressure Monitoring System (TPMS)
The Tire Pressure Monitoring System (TPMS) will warn the driver of a low tire pressure based on the vehicle recommended cold placard pressure. NOTE: The alert warning on the cluster will stay on until the tire is inflated to the placard pressure. The tire pressure will vary with temperature by approximately 1 psi (7 kPa) for every 12°F (6...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Turning FCW On Or Off
- WARNING LIGHTS AND MESSAGES
- How To Use Remote Start
- New on site
- Most important about car
Manual Front Seat Forward/Rearward Adjustment
The seat can be adjusted forward or rearward by using a bar located by the front of the seat cushion, near the floor. While sitting in the seat, lift up on the bar located under the seat cushion and move the seat forward or rearward. Release the bar once you have reached the desired position. Then, using body pressure, move forward and rearward on the seat to be sure that the seat adjusters have latched.
Adjustment Bar Location
Copyright © 2025 www.jewrangler.com