Jeep Wrangler: CLIMATE CONTROLS / Climate Voice Commands

Adjust vehicle temperatures hands-free and keep everyone comfortable while you keep moving ahead.

Push the VR button on the steering wheel. After the beep, say one of the following commands:

  • “Set the driver temperature to 70 degrees”
  • “Set the passenger temperature to 70 degrees”

Did You Know: Voice Command for Climate may only be used to adjust the interior temperature of your vehicle. Voice Command will not work to adjust the heated seats or steering wheel if equipped.

    Automatic Temperature Control (ATC) — If Equipped

    Automatic Operation Push the AUTO button on the faceplate, or the AUTO button on the touchscreen on the Automatic Temperature Control (ATC) Panel...

    Operating Tips

    NOTE: Refer to the chart at the end of this section for suggested control settings for various weather conditions. Summer Operation The engine cooling system must be protected with a high-quality antifreeze coolant to provide proper corrosion protection and to protect against engine overheating...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Radio Controls


    Uconnect 3 With 5-inch Display Preset Radio Stations All Preset Radio Stations Radio Band (AM/FM) Seek Down Tune Station Info Seek Up Audio Settings Uconnect 4 With 7-inch Display Radio Bands Preset Radio Stations View Next Preset Radio Stations Status Bar Browse Button Seek Down Tune Button Seek Up Audio Settings Bottom Bar The radio is equipped with the following modes: AM FM SiriusXM® Satellite Radio (if equipped) Press the Radio button on the touchscreen to enter the Radio Mode...

    Jeep Wrangler 2018-2026 Owners Manual: Headlight Switch


    The headlight switch is located on the left side of the instrument panel. This switch controls the operation of the headlights, parking lights, automatic headlights (if equipped), instrument panel lights, interior lights, and fog lights (if equipped)...

    Categories

    Turn Signals. Lane Change Assist — If Equipped

    Turn Signals

    Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

    NOTE:

    If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.

    read more

     
    Copyright © 2026 www.jewrangler.com