Jeep Wrangler: IN CASE OF EMERGENCY / JUMP STARTING
If your vehicle has a discharged battery, it can
be jump started using a set of jumper cables
and a battery in another vehicle, or by using a
portable battery booster pack. Jump starting
can be dangerous if done improperly, so please
follow the procedures in this section carefully.
WARNING!
Do not attempt jump starting if the battery is
frozen. It could rupture or explode and cause
personal injury.
CAUTION!
o not use a portable battery booster pack or
any other booster source with a system
voltage greater than 12 Volts or damage to
the battery, starter motor, alternator or
electrical system may occur.
NOTE:
When using a portable battery booster pack,
follow the manufacturer's operating instructions
and precautions.
WARNING!
Carefully follow these tire changing warnings
to help prevent personal injury or damage to
your vehicle:
Always park on a firm, level surface as far
from the edge of the roadway as possible
before raising the vehicle...
Supplemental Battery — If Equipped
WARNING!
Only use the positive battery post on the
main battery to jump start your vehicle.
Serious injury or death could result if you
attempt to jump start using the supplemental
battery...
Other information:
Programming the key fob may be
performed by an authorized dealer.NOTE:
Once a key fob is programmed to a vehicle, it
cannot be repurposed and reprogrammed to
another vehicle.
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle...
Install the front door rail first.
Carefully place the front door rail in the
rubber seal at the top of the windshield, and
line up the holes for the Torx head screws
(two for each door).
Swing the frame bracket around the side of
the rail, and insert the screws from
underneath...