Jeep Wrangler: GETTING TO KNOW YOUR VEHICLE / WINDSHIELD WIPERS AND WASHERS
The windshield wiper/washer control lever is
located on the right side of the steering column.
The front wipers are operated by rotating a
switch, located at the end of the lever.

Windshield Wiper/Washer Lever (If Equipped With Rear Wipers)
Dimmer Controls
Ambient Light Dimmer Control
Instrument Panel Dimmer Control
With the parking lights or headlights on, rotating
the right dimmer control upward will increase
the brightness of the instrument panel lights...
Rotate the end of the lever upward to the first
detent past the intermittent settings for
low-speed wiper operation. Rotate the end of
the lever upward to the second detent past the
intermittent settings for high-speed wiper
operation...
Other information:
Four-Wheel Drive Gear Selector
The transfer case provides four mode positions:
2H (2WD High) — Two-Wheel Drive High
Range
4H (4WD High) —Four-Wheel Drive High
Range
N (Neutral)
4L (4WD Low) — Four-Wheel Drive Low Range
For additional information on the appropriate
use of each transfer case mode position, see
the information below:
2WD High
Two-Wheel Drive High Range — This range is for
normal street and highway driving on dry, hard
surfaced roads...
If currently installed, remove the hard top.
Install the door rails, starting with the front,
followed by the rear on each side. For
instructions and appropriate torque specifications
for the door rail Torx screws.
Install the rear retainers on each side of the
rear of the vehicle using the provided
#50 Torx head driver and ratchet...