Jeep Wrangler: GETTING TO KNOW YOUR VEHICLE / POWER WINDOWS — IF EQUIPPED
The power window switches are located on the
instrument panel below the climate controls.
Push the switch downward to open the window
and upward to close the window.
The top left switch controls the left front window
and the top right switch controls the right front
window.
WARNING!
Never leave children unattended in a vehicle,
and do not let children play with power
windows. Do not leave the key fob in or near
the vehicle, or in a location accessible to
children. Occupants, particularly unattended
children, can become entrapped by the
windows while operating the power window
switches. Such entrapment may result in
serious injury or death.

Power Window Switches
To open the window part way (manually), push
the window switch down briefly and release.
NOTE:
The power window switches will remain active
for up to 10 minutes after ignition is placed in
the OFF position. Opening either front door will
cancel this feature.
Four-Door Models
The lower left switch controls the left rear
passenger window, and the lower right switch
controls the right rear passenger window.
NOTE:
There are window switches located on the rear
of the center console for the rear passenger
windows in the four-door model.
Four auxiliary switches located in the lower
switch bank of the instrument panel can be
used to power various electrical devices. You
have the ability to configure the functionality of
the auxiliary switches via the Uconnect Settings...
The driver door power and the passenger door
power window switches have an Auto-Down
feature. Push the window switch down to the
second detent and release, and the window will
go down automatically...
Other information:
The following tire grading categories were
established by the National Highway Traffic
Safety Administration. The specific grade rating
assigned by the tire's manufacturer in each
category is shown on the sidewall of the tires on
your vehicle.
All passenger vehicle tires must conform to
Federal safety requirements in addition to
these grades...
Four auxiliary switches located in the lower
switch bank of the instrument panel can be
used to power various electrical devices. You
have the ability to configure the functionality of
the auxiliary switches via the Uconnect Settings.
All switches can be configured as follows:
Switch type operation: Latching or Momentary
Power source: Battery or Ignition
Ability to hold last state across key cycles: On or Off
Auxiliary Switches
NOTE:
Holding last state conditions are met when
switch type is set to latching and power source
is set to ignition...