Jeep Wrangler: INTRODUCTION / Rollover Warning

Utility vehicles have a significantly higher rollover rate than other types of vehicles. This vehicle has a higher ground clearance and a higher center of gravity than many passenger vehicles. It is capable of performing better in a wide variety of off-road applications. Driven in an unsafe manner, all vehicles can go out of control. Because of the higher center of gravity, if this vehicle is out of control it may roll over while some other vehicles may not.

Do not attempt sharp turns, abrupt maneuvers, or other unsafe driving actions that can cause loss of vehicle control. Failure to operate this vehicle safely may result in a collision, rollover of the vehicle, and severe or fatal injury. Drive carefully.

Jeep Wrangler. Rollover Warning

Failure to use the driver and passenger seat belts provided is a major cause of severe or fatal injury. In fact, the US government notes that the universal use of existing seat belts could cut the highway death 10,000 or more each year and could reduce disabling injuries by two million annually. In a rollover crash, an unbelted person is significantly more likely to die than a person wearing a seat belt. Always buckle up.

    Symbols Key

    ..

    Vehicle Modifications, Alterations

    WARNING! Any modifications or alterations to this vehicle could seriously affect its roadworthiness and safety and may lead to a collision resulting in serious injury or death...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Manual Transmission — If Equipped


    Fluid Level Check Check the fluid level by removing the fill plug. The fluid level should be between the bottom of the fill hole and a point not more than 3/16 of an inch (4.76 mm) below the bottom of the hole. Add fluid, if necessary, to maintain the proper level...

    Jeep Wrangler 2018-2026 Owners Manual: Activating Adaptive Cruise Control (ACC)


    The minimum set speed for the ACC system is 20 mph (32 km/h). When the system is turned on and in the ready state, the instrument cluster displays “ACC Ready.” When the system is off, the instrument cluster displays “Adaptive Cruise Control (ACC) Off...

    Categories

    Basic Voice Commands

    The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

    “Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

    read more

     
    Copyright © 2026 www.jewrangler.com