Jeep Wrangler 2018-2026 Owners Manual / TECHNICAL SPECIFICATIONS / VEHICLE IDENTIFICATION NUMBER (VIN)
Jeep Wrangler: TECHNICAL SPECIFICATIONS / VEHICLE IDENTIFICATION NUMBER (VIN)
The VIN is found on the left front corner of the A-pillar, visible from outside of the vehicle through the windshield.
Vehicle Identification Number
NOTE:
It is illegal to remove or alter the VIN plate.
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic
brake systems. If either of the two hydraulic
systems loses normal capability, the remaining
system will still function...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Cooling System Notes
NOTE: When the vehicle is stopped after a few miles/ kilometers of operation, you may observe vapor coming from the front of the engine compartment. This is normally a result of moisture from rain, snow, or high humidity accumulating on the radiator and being vaporized when the thermostat opens, allowing hot engine coolant (antifreeze) to enter the radiator...
Jeep Wrangler 2018-2026 Owners Manual: Service 4WD Warning Light — If Equipped
This warning light will illuminate to signal a fault with the 4WD system. If the light stays on or comes on during driving, it means that the 4WD system is not functioning properly and that service is required. We recommend you drive to the nearest service center and have the vehicle serviced immediately...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- How To Use Remote Start
- WARNING LIGHTS AND MESSAGES
- The ASSIST and SOS Call Buttons On Your Rearview Mirror Or Overhead Console
- New on site
- Most important about car
Turn Signals. Lane Change Assist — If Equipped
Turn Signals
Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.
Copyright © 2026 www.jewrangler.com