Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / WARNING LIGHTS AND MESSAGES / Yellow Indicator Lights / Front And Rear Axle Lock Indicator Light
Jeep Wrangler: Yellow Indicator Lights / Front And Rear Axle Lock Indicator Light
This light indicates when the
front,
rear, or both axles have been locked.
The telltale will display the lock icon
on the front and rear axles to indicate
the current lock status.
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Enabling And Disabling ParkSense
ParkSense can be enabled and disabled with the ParkSense switch located below the Uconnect display. When the ParkSense switch is pushed to disable the system, the instrument cluster display will show the “PARKSENSE OFF” message for approximately five seconds...
Jeep Wrangler 2018-2026 Owners Manual: Activating Adaptive Cruise Control (ACC)
The minimum set speed for the ACC system is 20 mph (32 km/h). When the system is turned on and in the ready state, the instrument cluster displays “ACC Ready.” When the system is off, the instrument cluster displays “Adaptive Cruise Control (ACC) Off...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- WARNING LIGHTS AND MESSAGES
- Display Warnings And Maintenance
- Jack Location
- New on site
- Most important about car
Turn Signals. Lane Change Assist — If Equipped
Turn Signals
Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.
Copyright © 2026 www.jewrangler.com