Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / WARNING LIGHTS AND MESSAGES / Yellow Indicator Lights / Forward Collision Warning (FCW) OFF Indicator Light — If Equipped

Jeep Wrangler: Yellow Indicator Lights / Forward Collision Warning (FCW) OFF Indicator Light — If Equipped

Jeep Wrangler. Forward Collision Warning (FCW) OFF Indicator Light — If Equipped This indicator light illuminates to indicate that Forward Collision Warning is off.

Axle Locker Fault Indicator Light

Front And Rear Axle Lock Indicator Light

This light indicates when the front, rear, or both axles have been locked. The telltale will display the lock icon on the front and rear axles to indicate the current lock status...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: ENGINE BLOCK HEATER — IF EQUIPPED

The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. Diesel Engine Block Heater Cord Location The engine block heater cord is found under the hood bundled up next to the Power Distribution Center (PDC)...

Jeep Wrangler 2018-2026 Owners Manual: Full Off — If Equipped

The “Full Off” mode is intended for off-highway or off-road use only and should not be used on any public roadways. In this mode, TCS and ESC features are turned off. To enter the “Full Off” mode, push and hold the ESC OFF switch for five seconds while the vehicle is stopped with the engine running...

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.