Jeep Wrangler: Yellow Indicator Lights / Axle Locker Fault Indicator Light

Jeep Wrangler. Axle Locker Fault Indicator Light This light indicates when the front and/or rear axle locker fault has been detected.

    4WD Part Time Indicator Light — If Equipped

    This light alerts the driver that the vehicle is in the four-wheel drive part time mode, and the front and rear driveshafts are mechanically locked together forcing the front and rear wheels to rotate at the same speed...

    Forward Collision Warning (FCW) OFF Indicator Light — If Equipped

    ..

    Other information:

    Jeep Wrangler 2018-2025 Owners Manual: Enabling And Disabling ParkSense


    ParkSense can be enabled and disabled with the ParkSense switch located below the Uconnect display. When the ParkSense switch is pushed to disable the system, the instrument cluster display will show the “PARKSENSE OFF” message for approximately five seconds...

    Jeep Wrangler 2018-2025 Owners Manual: Lap/Shoulder Belt Untwisting Procedure


    Use the following procedure to untwist a twisted lap/shoulder belt. Position the latch plate as close as possible to the anchor point. At about 6 to 12 inches (15 to 30 cm) above the latch plate, grab and twist the seat belt webbing 180 degrees to create a fold that begins immediately above the latch plate...

    Categories

    Manual Front Seat Forward/Rearward Adjustment

    The seat can be adjusted forward or rearward by using a bar located by the front of the seat cushion, near the floor. While sitting in the seat, lift up on the bar located under the seat cushion and move the seat forward or rearward. Release the bar once you have reached the desired position. Then, using body pressure, move forward and rearward on the seat to be sure that the seat adjusters have latched.

    Jeep Wrangler. Manual Front Seat Forward/Rearward Adjustment

    Adjustment Bar Location

    read more

     
    Copyright © 2025 www.jewrangler.com