Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR VEHICLE / KEYS / Programming And Requesting Additional Key Fobs

Jeep Wrangler: KEYS / Programming And Requesting Additional Key Fobs

Programming the key fob may be performed by an authorized dealer.
NOTE:
- Once a key fob is programmed to a vehicle, it cannot be repurposed and reprogrammed to another vehicle.
- Only key fobs that are programmed to the vehicle electronics can be used to start and operate the vehicle.
WARNING!
- Always remove the key fobs from the vehicle and lock all doors when leaving the vehicle unattended.
- Always remember to place the ignition in the OFF position.
Duplication of key fobs may be performed at an authorized dealer. This procedure consists of programming a blank key fob to the vehicle electronics.
NOTE:
- When having the Sentry Key Immobilizer system serviced, bring all vehicle keys with you to an authorized dealer.
- Keys must be ordered to the correct key cut to match the vehicle locks.

Replacing The Battery In The Key Fob

The recommended replacement battery is CR2450. NOTE: Customers are recommended to use a battery obtained from Mopar®. Aftermarket coin battery dimensions may not meet the original OEM coin battery dimensions...

SENTRY KEY

The Sentry Key Immobilizer system prevents unauthorized vehicle operation by disabling the engine. The system does not need to be armed or activated...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Selec-Speed Control (SSC) — If Equipped

SSC is intended for off-road driving in 4WD Low only. SSC maintains vehicle speed by actively controlling engine torque and brakes. SSC has three states: Off (feature is not enabled and will not activate) Enabled (feature is enabled and ready but activation conditions are not met, or driver is actively overriding with brake or throttle application) Active (feature is enabled and actively controlling vehicle speed) Enabling SSC SSC is enabled by pushing the SSC switch, but the following conditions must also be met to enable SSC: The driveline is in 4WD Low...

Jeep Wrangler 2018-2026 Owners Manual: Four Wheel Drive Models

FCA US LLC recommends towing with all wheels OFF the ground. Acceptable methods are to tow the vehicle on a flatbed or with one end of the vehicle raised and the opposite end on a towing dolly. If flatbed equipment is not available and the transfer case is operable, the vehicle may be towed (in the forward direction, with ALL wheels on the ground), IF the transfer case is in NEUTRAL (N) and the transmission is in PARK (P) (for automatic transmissions) or in gear NOT in NEUTRAL, for manual transmissions)...

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.