Jeep Wrangler: Green Indicator Lights / Turn Signal Indicator Lights
When the left or right turn
signal is
activated, the turn signal indicator will
flash independently and the
corresponding exterior turn signal
lamps will flash. Turn signals can be activated
when the multifunction lever is moved down
(left) or up (right).
NOTE:
A continuous chime will sound if the vehicle is driven more than 1 mile (1.6 km) with either turn signal on.
Check for an inoperative outside light bulb if either indicator flashes at a rapid rate.
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Service The ParkSense Rear Park Assist System
During vehicle start up, when the ParkSense Rear Park Assist System has detected a faulted condition, the instrument cluster display will actuate a single chime, once per ignition cycle, and it will display the “PARKSENSE UNAVAILABLE WIPE REAR SENSORS” or the “PARKSENSE UNAVAILABLE SERVICE REQUIRED” message...
Jeep Wrangler 2018-2026 Owners Manual: CNG And LP Fuel System Modifications. MMT In Gasoline
CNG And LP Fuel System Modifications Modifications that allow the engine to run on Compressed Natural Gas (CNG) or Liquid Propane (LP) may result in damage to the engine, emissions, and fuel system components. Problems that result from running CNG or LP are not the responsibility of the manufacturer and may void or not be covered under the New Vehicle Limited Warranty...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Draining Fuel/Water Separator Filter — Diesel Engine
- UCONNECT SETTINGS
- SERVICING AND MAINTENANCE
- New on site
- Most important about car
Manual Seat Height Adjustment
The driver's seat height can be raised or lowered by using the ratcheting handle, located on the outboard side of the seat. Pull upward on the handle to raise the seat, push downward on the handle to lower the seat. Several strokes may be necessary to achieve the desired position.
Seat Height Adjustment
