Jeep Wrangler: Electronic Stability Control (ESC) / Rain Brake Support (RBS)
RBS may improve braking performance in wet conditions. It will periodically apply a small amount of brake pressure to remove any water buildup on the front brake rotors. It functions when the windshield wipers are in LO or HI speed. When RBS is active, there is no notification to the driver and no driver interaction is required.
Hill Start Assist (HSA)
The HSA system is designed to mitigate roll
back from a complete stop while on an incline.
If the driver releases the brake while stopped on
an incline, HSA will continue to hold the brake
pressure for a short period...
Ready Alert Braking (RAB)
RAB may reduce the time required to reach full
braking during emergency braking situations. It
anticipates when an emergency braking
situation may occur by monitoring how fast the
throttle is released by the driver...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Power Sliding Top — If Equipped
CAUTION! Lowering of the windshield is NOT recommended in vehicles equipped with a Power Sliding Top. Damage will occur to the top as well as the header seal. If your vehicle is equipped with a Power Sliding Top, the control switch can be found on the front trim panel, to the right of the driver’s side sun visor...
Jeep Wrangler 2018-2026 Owners Manual: Opening And Closing The Power Top
Express Open/Close Push the open switch and release it within one-half second and the power top will open automatically from any position. The power top will open fully and stop automatically. Push the close switch and release it within one-half second and the sunroof will close automatically from any position...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Service 4WD Warning Light — If Equipped
- Draining Fuel/Water Separator Filter — Diesel Engine
- UCONNECT SETTINGS
- New on site
- Most important about car
Automatic Headlights — If Equipped, Lights-On Reminder
Automatic Headlights
This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, rotate the headlight switch clockwise to the last detent for automatic headlight operation. When the system is on, the headlight time delay feature is also on. This means the headlights will stay on for up to 90 seconds after you place the ignition into the OFF position. To turn the automatic system off, move the headlight switch out of the AUTO position.
