Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / WARNING LIGHTS AND MESSAGES / Yellow Indicator Lights / Low Diesel Emissions Additive AdBlue® (UREA) Indicator Light — If Equipped

Jeep Wrangler: Yellow Indicator Lights / Low Diesel Emissions Additive AdBlue® (UREA) Indicator Light — If Equipped

Jeep Wrangler. Low Diesel Emissions Additive AdBlue® (UREA) Indicator Light — If Equipped The Low Diesel Exhaust Emissions Additive AdBlue® (UREA) indicator light illuminates when the AdBlue® (UREA) level is low.

Fill the AdBlue® (UREA) tank as soon as possible with at least 1.3 gallons (5 liters) of AdBlue® (UREA).

If filling the tank is done with a remaining range of AdBlue® (UREA) in the tank equal to zero, you may need to wait two minutes before starting the vehicle.

    Wait To Start Light — If Equipped

    This indicator light will illuminate for approximately two seconds when the ignition is turned to the ON/RUN position. Its duration may be longer based on colder operating conditions...

    Water In Fuel Indicator Light — If Equipped

    The “Water In Fuel Indicator Light” will illuminate when there is water detected in the fuel filter. If this light remains on, DO NOT start the vehicle before you drain the water from the fuel filter to prevent engine damage, and please see an authorized dealer...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Remove The Right And Left Quarter Windows:


    Through the rear opening, push the bottom corner outward and release tab from the bottom of the window pillar. Step One Undo the hook-and-loop fastener located at the upper front corner of each quarter window. Step Two Starting at the rear of the vehicle, remove plastic retainer from along the bottom of the window moving toward the front of the vehicle...

    Jeep Wrangler 2018-2026 Owners Manual: Before You Begin Programming HomeLink®


    For efficient programming and accurate transmission of the radio-frequency signal, it is recommended that a new battery be placed in the hand-held transmitter of the device that is being programmed to the HomeLink® system. Make sure your hand-held transmitter is programmed to activate the device you are trying to program your HomeLink® button to...

    Categories

    Manual Seat Height Adjustment

    The driver's seat height can be raised or lowered by using the ratcheting handle, located on the outboard side of the seat. Pull upward on the handle to raise the seat, push downward on the handle to lower the seat. Several strokes may be necessary to achieve the desired position.

    Jeep Wrangler. Manual Seat Height Adjustment

    Seat Height Adjustment

    read more

     
    Copyright © 2026 www.jewrangler.com