Jeep Wrangler: Yellow Indicator Lights / Wait To Start Light — If Equipped
This indicator light will
illuminate for
approximately two seconds when the
ignition is turned to the ON/RUN
position. Its duration may be longer
based on colder operating conditions. Vehicle
will not initiate start until telltale is no longer
displayed.
NOTE:
The “Wait To Start” telltale may not illuminate if
the intake manifold temperature is warm
enough.
The Low Diesel Exhaust Emissions
Additive AdBlue® (UREA) indicator
light illuminates when the AdBlue®
(UREA) level is low.
Fill the AdBlue® (UREA) tank as soon as
possible with at least 1...
Other information:
NOTE:
Under no circumstances should oil change
intervals exceed 8,000 miles (12,875 km) or
six months, whichever comes first when
using biodiesel blends greater than 5% (B5).
The owner is required to monitor mileage for
B6-B20 biodiesel, the automatic oil change
indicator system does not reflect the use of
biofuels...
Remove both front panels.
Open both front doors.
Using the provided #50 Torx head driver
and ratchet, remove the two Torx head
screws that secure the hard top at the
B-pillar (near the top of the front doors).
Step Three
Remove the six Torx head screws that
secure the hard top to the vehicle (along the
interior bodyside — three screws on each
side) using the #50 Torx head driver...