Jeep Wrangler: Manual Climate Control Descriptions And Functions / Rear Defrost Button

Jeep Wrangler. Rear Defrost Button Push and release the Rear Defrost Control button to turn on the rear window defroster and the heated outside mirrors (if equipped). The Rear Defrost indicator illuminates when the rear window defroster is on. The rear window defroster automatically turns off after 10 minutes.

CAUTION!

Failure to follow these cautions can cause damage to the heating elements:

  • Use care when washing the inside of the rear window. Do not use abrasive window cleaners on the interior surface of the window. Use a soft cloth and a mild washing solution, wiping parallel to the heating elements. Labels can be peeled off after soaking with warm water.
  • Do not use scrapers, sharp instruments, or abrasive window cleaners on the interior surface of the window.
  • Keep all objects a safe distance from the window.

    Front Defrost Setting

    Turn the Mode Control knob to the Front Defrost mode setting. Air comes from the windshield and side window demist outlets. When the Defrost button is selected, the blower level may increase...

    Temperature Control

    Temperature Control regulates the temperature of the air forced through the climate system. The temperature increases as you turn the temperature control knob clockwise...

    Other information:

    Jeep Wrangler 2018-2025 Owners Manual: ENGINE BLOCK HEATER — IF EQUIPPED


    The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. Diesel Engine Block Heater Cord Location The engine block heater cord is found under the hood bundled up next to the Power Distribution Center (PDC)...

    Jeep Wrangler 2018-2025 Owners Manual: ACC Operation At A Stop (Automatic Transmission Only)


    In the event that the ACC system brings your vehicle to a standstill while following a vehicle ahead, your vehicle will resume motion, without any driver interaction, if the vehicle ahead starts moving within two seconds of your vehicle coming to a standstill...

    Categories

    Turn Signals. Lane Change Assist — If Equipped

    Turn Signals

    Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

    NOTE:

    If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.

    read more

     
    Copyright © 2025 www.jewrangler.com