Jeep Wrangler 2018-2025 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / WARNING LIGHTS AND MESSAGES / White Indicator Lights / Cruise Control Ready Indicator Light — If Equipped With A Premium Instrument Cluster

Jeep Wrangler: White Indicator Lights / Cruise Control Ready Indicator Light — If Equipped With A Premium Instrument Cluster

Jeep Wrangler. Cluster This light will turn on when the Cruise Control has been turned on, but not set.

    Selec-Speed Control Indicator Light — If Equipped

    This light will turn on when “Selec-Speed Control” is activated. To activate “Selec-Speed Control”, ensure the vehicle is in 4WD Low and push the button on the Instrument Panel...

    Cruise Control SET Indicator Light — If Equipped With Base Instrument Cluster

    ..

    Other information:

    Jeep Wrangler 2018-2025 Owners Manual: Instrument Cluster Display Location And Controls


    The instrument cluster display is located in the center of the instrument cluster. Instrument Cluster Display Location The system allows the driver to select information by pushing the following buttons mounted on the steering wheel: Instrument Cluster Display Control Buttons Left Arrow Button Up Arrow Button Right Arrow Button Down Arrow Button OK Button Up And Down Arrow Buttons: Using the up or down arrow button allows you to cycle through the Main Menu Items...

    Jeep Wrangler 2018-2025 Owners Manual: Trailer And Tongue Weight


    Never exceed the maximum tongue weight stamped on your bumper or trailer hitch. Weight Distribution Consider the following items when computing the weight on the rear axle of the vehicle: The tongue weight of the trailer. The weight of any other type of cargo or equipment put in or on your vehicle...

    Categories

    Basic Voice Commands

    The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

    “Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

    read more

     
    Copyright © 2025 www.jewrangler.com