Jeep Wrangler 2018-2026 Owners Manual / STARTING AND OPERATING / DRIVING TIPS / Off-Road Driving Tips / Side Step Removal — If Equipped

Jeep Wrangler: Off-Road Driving Tips / Side Step Removal — If Equipped

NOTE:

Prior to off-road usage, the side steps should be removed to prevent damage if so equipped.

Remove both nuts and bolt from the underside of the vehicle for each bracke

Underside Nuts
Remove the side step assembly.

Bumper End Cap Removal

The end caps on your vehicle’s front fascia/ bumper can be removed by following the steps below: NOTE: Bumper end caps are removable on steel fascia/bumper only...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Programming HomeLink® To A Miscellaneous Device

The procedure on how to program HomeLink® to a miscellaneous device follows the same procedure as programming to a garage door opener. Be sure to determine if the device has a rolling code, or non-rolling code before beginning the programming process...

Jeep Wrangler 2018-2026 Owners Manual: LED Front Fog Lamp

If your vehicle is equipped with LED fog lamps they are replaced as an assembly. Rear Tail, Stop, Turn Signal, And Backup Lamp See below steps to replace: Remove interior trim panel cap to access single retaining screw for tail lamp assembly. Trim Cap Remove retaining screw and disconnect electrical connector, then remove tail lamp assembly from the vehicle...

Manual Seat Height Adjustment

The driver's seat height can be raised or lowered by using the ratcheting handle, located on the outboard side of the seat. Pull upward on the handle to raise the seat, push downward on the handle to lower the seat. Several strokes may be necessary to achieve the desired position.

Jeep Wrangler. Manual Seat Height Adjustment

Seat Height Adjustment