Jeep Wrangler: WRANGLER TOPS / Raising The Soft Top

Jeep Wrangler. Raising The Soft Top

Use this QR code to access your digital experience.

Lowering The Soft Top All The Way

Remove the rear window and quarter panel windows. From the Sunrider® position, remove straps if previously secured and move to the rear of the vehicle...

Raising The Soft Top From The Fully Lowered Position

From the fully lowered position, remove straps if previously secured.CAUTION! Failure to follow the next steps could result in damage to the Soft Top or vehicle...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Selec-Speed Control (SSC) — If Equipped


SSC is intended for off-road driving in 4WD Low only. SSC maintains vehicle speed by actively controlling engine torque and brakes. SSC has three states: Off (feature is not enabled and will not activate) Enabled (feature is enabled and ready but activation conditions are not met, or driver is actively overriding with brake or throttle application) Active (feature is enabled and actively controlling vehicle speed) Enabling SSC SSC is enabled by pushing the SSC switch, but the following conditions must also be met to enable SSC: The driveline is in 4WD Low...

Jeep Wrangler 2018-2026 Owners Manual: Hard Top Components


Four Door Hard Top Components Right Side Panel Left Side Panel Hard Top Two Door Hard Top Components Right Side Panel Left Side Panel Hard Top NOTE: All hard top removal and installation instructions are applicable to both two and four door model vehicles...

Categories

Basic Voice Commands

The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

“Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

read more

 
Copyright © 2026 www.jewrangler.com