Jeep Wrangler: Raising The Soft Top / Raising The Soft Top From The Fully Lowered Position

  1. From the fully lowered position, remove straps if previously secured.

    CAUTION!

    Failure to follow the next steps could result in damage to the Soft Top or vehicle.

  2. While pushing down on the rear of the top, slide the lock lever on the left and right side lift assist mechanisms to the “unlock” position.

    Jeep Wrangler. Raising The Soft Top From The Fully Lowered Position

    Step Two

  3. Push up and forward from the #5 Bow along the guide track until it locks into the Sunrider® position with an audible “click”.

    Jeep Wrangler. Raising The Soft Top From The Fully Lowered Position

    Step Three

  4. Gently pull rearward on the #6 Bow to ensure the top is locked in the Sunrider® position.
  5. Using the side link, lift and push the soft top toward the front of the vehicle manually guiding the top into the closed position.

    Jeep Wrangler. Raising The Soft Top From The Fully Lowered Position

    Step Five

    Jeep Wrangler. Raising The Soft Top From The Fully Lowered Position

    Step Five

  6. From inside the vehicle, pull the handle on the header latch downward to engage the hook into its receiver. Repeat on the other side.

    Jeep Wrangler. Raising The Soft Top From The Fully Lowered Position

    Step Six

  7. Pull the handle back upward while squeezing the hook, locking the latch into place.

    Jeep Wrangler. Raising The Soft Top From The Fully Lowered Position

    Step Seven

    Raising The Soft Top

    ..

    Installing The Soft Top Windows

    Install The Right And Left Quarter Windows From the rear of the vehicle, guide the top of the window into the retainer and slide forward while keeping the window level...

    Other information:

    Jeep Wrangler 2018-2024 Owners Manual: Checking Oil Level


    To ensure proper engine lubrication, the engine oil must be maintained at the correct level. Check the oil level at regular intervals, such as every fuel stop. The best time to check the engine oil level is about five minutes after a fully warmed up engine is shut off...

    Jeep Wrangler 2018-2024 Owners Manual: Selec-Speed Control Indicator Light — If Equipped


    This light will turn on when “Selec-Speed Control” is activated. To activate “Selec-Speed Control”, ensure the vehicle is in 4WD Low and push the button on the Instrument Panel. NOTE: If the vehicle is not in 4WD Low, “To Enter Selec-Speed Shift to 4WD Low” will appear in the instrument cluster display...

    Categories

    Bi-Level Mode

    Jeep Wrangler. Bi-Level Mode Air comes from the instrument panel outlets and floor outlets. A slight amount of air is directed through the defrost and side window demister outlets.

    NOTE:

    Bi-Level mode is designed under comfort conditions to provide cooler air out of the panel outlets and warmer air from the floor outlets.

    read more

     
    Copyright © 2024 www.jewrangler.com