Jeep Wrangler 2018-2026 Owners Manual / MULTIMEDIA / OFF-ROAD PAGES — IF EQUIPPED / Off-Road Pages Status Bar
Jeep Wrangler: OFF-ROAD PAGES — IF EQUIPPED / Off-Road Pages Status Bar
The Off-Road Pages Status Bar is located along the bottom of Off-Road Pages and is present in each of the three selectable page options. It provides continually updating information for the following items:
- Current Transfer Case Status
- Current Latitude/Longitude
- Current Altitude of the vehicle
- Status of Hill Descent/Selec-Speed Control and Selected Speed in MPH (km/h)
- Status of Off-Road+ Mode
Status Bar 2WD/4WD
- Transfer Case Status
- Current Latitude/Longitude
- Current Altitude
- Hill Descent Control
OFF-ROAD PAGES — IF EQUIPPED
If your vehicle is equipped with Off-Road Pages,
it will provide you vehicle status while operating
on off-road conditions. It supplies information
relating to the status of the drivetrain, transfer
case, coolant/oil gauges, pitch and roll of the
vehicle and access to the trailcam system...
Drivetrain
T..
Other information:
Jeep Wrangler 2018-2026 Owners Manual: High Beam Indicator Light
This indicator light will illuminate to indicate that the high beam headlights are on. With the low beams activated, push the multifunction lever forward (toward the front of the vehicle) to turn on the high beams. Pull the multifunction lever rearward (toward the rear of the vehicle) to turn off the high beams...
Jeep Wrangler 2018-2026 Owners Manual: Manual Transmission — If Equipped
Apply the parking brake, place the gear selector in NEUTRAL, and press the clutch pedal before starting the vehicle. This vehicle is equipped with a clutch interlocking ignition system. It will not start unless the clutch pedal is pressed to the floor...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Engine Coolant Level — 2.0L
- Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass
- SERVICING AND MAINTENANCE
- New on site
- Most important about car
Manual Seat Height Adjustment
The driver's seat height can be raised or lowered by using the ratcheting handle, located on the outboard side of the seat. Pull upward on the handle to raise the seat, push downward on the handle to lower the seat. Several strokes may be necessary to achieve the desired position.
Seat Height Adjustment
Copyright © 2026 www.jewrangler.com