Jeep Wrangler: Manual Climate Control Descriptions And Functions / Mode Control
Turn the mode control knob to
adjust
airflow distribution. The airflow
distribution mode can be adjusted so
air comes from the instrument panel
outlets, floor outlets, defrost outlets and demist
outlets.
Blower Control regulates the
amount
of air forced through the climate
system. There are seven blower
speeds available. The blower speeds
increase as you turn the blower control knob
clockwise from the lowest blower setting...
Air comes from the outlets in
the
instrument panel. Each of these
outlets can be individually adjusted to
direct the flow of air. The air vanes of
the center outlets and outboard outlets can be
moved up and down or side to side to regulate
airflow direction...
Other information:
When off-road driving, shift into 4WD Low for
additional traction and control on slippery or
difficult terrain, ascending or descending steep
hills, and to increase low speed pulling power.
This range should be limited to extreme
situations such as deep snow, mud, steep
inclines, or sand where additional low speed
pulling power is needed...
Remove the rear seats.
Remove the sides grommets (one left and
one right). First the grommet from the side
carpet and then the rear carpet.
Side Carpet
Remove the grommets under the front seat
(one left and one right).
Then pull the carpet out to the rear and
open the carpet split around the front seats
brackets...