Jeep Wrangler: VEHICLE MAINTENANCE / Fuses

Selection Of Lubricant

It is important to use the proper transmission fluid to ensure optimum transmission performance and life. Use only the manufacturer specified transmission fluid...

General Information

WARNING! When replacing a blown fuse, always use an appropriate replacement fuse with the same amp rating as the original fuse. Never replace a fuse with another fuse of higher amp rating...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Power Sliding Top — If Equipped


CAUTION! Lowering of the windshield is NOT recommended in vehicles equipped with a Power Sliding Top. Damage will occur to the top as well as the header seal. If your vehicle is equipped with a Power Sliding Top, the control switch can be found on the front trim panel, to the right of the driver’s side sun visor...

Jeep Wrangler 2018-2026 Owners Manual: Axle Lock (Tru-Lok) Rear Only — If Equipped


The rear axle may be locked in 4WD High if the proper conditions are met. WARNING! This mode is intended for off-highway or off-road use only and should not be used on any public roadways. The AXLE LOCK switch is located on the instrument panel (to the right of the steering column)...

Categories

Turn Signals. Lane Change Assist — If Equipped

Turn Signals

Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

NOTE:

If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.

read more

 
Copyright © 2026 www.jewrangler.com