Jeep Wrangler: Fuses / Power Distribution Center (PDC)

The Power Distribution Center is located in the engine compartment near the battery. This center contains cartridge fuses, mini fuses, and relays. The PDC top cover is labeled with each serviceable fuse/relay location, function, and size.

Jeep Wrangler. Power Distribution Center (PDC)

Power Distribution Center Location

Jeep Wrangler. Power Distribution Center (PDC)

Power Distribution Center

Jeep Wrangler. Power Distribution Center (PDC)

Jeep Wrangler. Power Distribution Center (PDC)

Jeep Wrangler. Power Distribution Center (PDC)

Jeep Wrangler. Power Distribution Center (PDC)

Jeep Wrangler. Power Distribution Center (PDC)

Jeep Wrangler. Power Distribution Center (PDC)

Jeep Wrangler. Power Distribution Center (PDC)

* If Equipped

Customer can select to switch the Cargo Power Outlet from F43 battery fed power to this position F45 which is fed when the ignition in ON.

Jeep Wrangler. Power Distribution Center (PDC)

    General Information

    WARNING! When replacing a blown fuse, always use an appropriate replacement fuse with the same amp rating as the original fuse. Never replace a fuse with another fuse of higher amp rating...

    Bulb Replacement

    ..

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Extreme Cold Weather


    The engine block heater is a resistance heater installed in the water jacket of the engine. It requires a 110–115 Volt AC electrical outlet with a grounded, three-wire extension cord. Its use is recommended for environments that routinely fall below -10°F (-23°C)...

    Jeep Wrangler 2018-2026 Owners Manual: Drag & Drop Menu Bar


    The Uconnect features and services in the main menu bar are easily customized for your preference. Simply follow these steps: Uconnect 4 With 7-inch Display Drag & Drop Press the Apps button to open the App screen. Press and hold, then drag the selected app to replace an existing shortcut in the main menu bar...

    Categories

    Basic Voice Commands

    The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

    “Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

    read more

     
    Copyright © 2026 www.jewrangler.com