Jeep Wrangler: Electronic Stability Control (ESC) / Full Off — If Equipped
The “Full Off” mode is intended for off-highway
or off-road use only and should not be used on
any public roadways. In this mode, TCS and ESC
features are turned off. To enter the “Full Off”
mode, push and hold the ESC OFF switch for five
seconds while the vehicle is stopped with the
engine running. After five seconds, a chime will
sound, the ESC OFF Indicator Light will
illuminate, and the “ESC Off” message will
display in the instrument cluster. To turn ESC on
again, momentarily push the ESC OFF switch.
NOTE:
System may switch from ESC “Full Off” to
“Partial Off” mode when vehicle exceeds a
predetermined speed. When the vehicle speed
slows below the predetermined speed the
system will return to ESC “Full Off”.
If equipped with Off Road+ and if Off Road+ is
active when "Full Off" mode is enabled by the
driver, ESC will not switch to "Partial Off" mode
at any speed and will remain in "Full Off" mode
until Off Road+ is exited or ESC is re-enabled by
the driver.
WARNING!
- In the ESC “Full Off” mode, the engine
torque reduction and stability features are
disabled. Therefore, enhanced vehicle
stability offered by the ESC system is
unavailable. In an emergency evasive
maneuver, the ESC system will not engage
to assist in maintaining stability. ESC “Full
Off” mode is intended for off-highway or
off-road use only.
- The Electronic Stability Control (ESC)
cannot prevent the natural laws of physics
from acting on the vehicle, nor can it
increase the traction afforded by prevailing
road conditions. ESC cannot prevent all
accidents, including those resulting from
excessive speed in turns, driving on very
slippery surfaces, or hydroplaning. ESC also
cannot prevent collisions.
Depending upon model and mode of operation,
the ESC system may have multiple operating
modes.
ESC On
“ESC On” is the normal operating mode for the
ESC...
The ESC Activation/Malfunction
Indicator Light in the instrument
cluster will come on when the ignition
is turned to the “ESC On” mode. It
should go out with the engine running...
Other information:
This warning light warns of an
overheated engine condition. If the
engine coolant temperature is too
high, this indicator will illuminate and
a single chime will sound. If the temperature
reaches the upper limit, a continuous chime will
sound for four minutes or until the engine is
able to cool, whichever comes first...
Automatic High Beam Headlamp Control
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automatically controlling the high
beams through the use of a camera mounted
on the vehicle’s header. This camera detects
vehicle specific light and automatically switches
from high beams to low beams until the
approaching vehicle is out of view...