Jeep Wrangler: TRAILCAM SYSTEM — IF EQUIPPED / Cleaning The TrailCam
Press and hold the “Clean Camera” soft button
located on the TrailCam view to wash the
TrailCam. Washer fluid will stop when the
button is released.
- The camera can be washed up to 20 seconds
at a time while holding the button.
- The “Clean Camera” system is not available
when windshield washing is in process.
When enabled, active dynamic Tire Lines are
projected on the ground plane of the TrailCam
view based on the steering wheel position.
TrailCam view can be activated via the below
methods:
Press the “FWD Camera” button on the
controls screen.
Press the “Forward Facing Camera” button
on the apps menu...
Other information:
Engine Oil Selection — 2.0L Engine (If Equipped)
For best performance and maximum protection
under all types of operating conditions, the
manufacturer only recommend engine oils that
are API SP/GF-6A certified and meet the
requirements of the manufacturer Material
Standard MS-13340...
Rotate the end of the lever upward to the first
detent past the intermittent settings for
low-speed wiper operation. Rotate the end of
the lever upward to the second detent past the
intermittent settings for high-speed wiper
operation.
Windshield/Intermittent Wiper Operation
CAUTION!
In cold weather, always turn off the wiper
switch and allow the wipers to return to the
park position before turning off the engine...