Jeep Wrangler: UNIVERSAL GARAGE DOOR OPENER (HOMELINK®) — IF EQUIPPED / Reprogramming A Single HomeLink® Button
To reprogram a single HomeLink® button that
has been previously trained, without erasing all
the channels, follow the procedure below. Be
sure to determine if the new device you want to
program the HomeLink® button to has a rolling
code or a non-rolling code.
- Place the ignition in the ON/RUN position,
without starting the engine.
- Push and hold the desired HomeLink®
button until the HomeLink® Indicator light
begins to flash after 20 seconds. Do not
release the button.
- Without releasing the button, proceed with
Step 2 in “Programming HomeLink® To A
Garage Door Opener” and follow all
remaining steps.
The procedure on how to program HomeLink®
to a miscellaneous device follows the same
procedure as programming to a garage door
opener.
Be sure to determine if the device has a rolling
code, or non-rolling code before beginning the
programming process...
For programming transmitters in Canada/
United States that require the transmitter
signals to “time-out” after several seconds of
transmission.
Canadian radio frequency laws require
transmitter signals to time-out (or quit) after
several seconds of transmission – which may
not be long enough for HomeLink® to pick up
the signal during programming...
Other information:
If your vehicle is equipped with Off-Road Pages,
it will provide you vehicle status while operating
on off-road conditions. It supplies information
relating to the status of the drivetrain, transfer
case, coolant/oil gauges, pitch and roll of the
vehicle and access to the trailcam system...
S..
Categories
To erase the channels, follow this procedure:
Place the ignition switch into the ON/RUN
position.
Push and hold the two outside HomeLink®
buttons (I and III) for up to 20 seconds, or
until the HomeLink® indicator light flashes.
NOTE:
Erasing all channels should only be performed
when programming HomeLink® for the first
time. Do not erase channels when programming
additional buttons.
read more