Jeep Wrangler: VEHICLE MAINTENANCE / Transfer Case
Fluid Level Check
The fluid level should be to the bottom edge of
the fill hole when the vehicle is in a level
position.

Transfer Case
- Fill hole
- Drain hole
Drain And Refill
For the proper maintenance intervals.
Selection Of Lubricant
Use only the manufacturer recommended fluid.
For normal service, periodic fluid level checks
are not required. When the vehicle is serviced
for other reasons the exterior surfaces of the
axle assembly should be inspected...
Fluid Level Check
Check the fluid level by removing the fill plug.
The fluid level should be between the bottom of
the fill hole and a point not more than 3/16 of
an inch (4...
Other information:
This system uses the key fob to
start
the engine conveniently from outside
the vehicle while still maintaining
security. The system has a range of
approximately 300 ft (91 m).
Remote Start is used to defrost windows in cold
weather, and to reach a comfortable climate in
all ambient conditions before the driver enters
the vehicle...
Blower Control regulates the
amount
of air forced through the Climate
Control system. Adjusting the blower
will cause automatic mode to switch
to manual operation. There are seven blower
speeds available. The speeds can be selected
using either the blower control knob on the
faceplate or the buttons on the touchscreen...