Jeep Wrangler: Off-Road Driving Tips / The Basics Of Off-Road Driving
You will encounter many types of terrain driving
off-road. You should be familiar with the terrain
and area before proceeding. There are many
types of surface conditions: hard-packed dirt,
gravel, rocks, grass, sand, mud, snow and ice.
Every surface has a different effect on your
vehicle's steering, handling and traction.
Controlling your vehicle is one of the keys to
successful off-road driving, so always keep a
firm grip on the steering wheel and maintain a
good driving posture. Avoid sudden accelerations, turns or braking. In most
cases,
there are no road signs, posted speed limits or
signal lights. Therefore, you will need to use
your own good judgment on what is safe and
what is not. When on a trail, you should always
be looking ahead for surface obstacles and
changes in terrain. The key is to plan your future
driving route while remembering what you are
currently driving over.
NOTE:
It is recommended that the Stop/Start System
be disabled during off-road use.
WARNING!
Always wear your seat belt and firmly tie down
cargo. Unsecured cargo can become
projectiles in an off-road situation.
CAUTION!
Never park your vehicle over dry grass or
other combustible materials. The heat from
your vehicle exhaust system could cause a
fire.
The end caps on your vehicle’s front fascia/
bumper can be removed by following the steps
below:
NOTE:
Bumper end caps are removable on steel
fascia/bumper only...
When off-road driving, shift into 4WD Low for
additional traction and control on slippery or
difficult terrain, ascending or descending steep
hills, and to increase low speed pulling power...
Other information:
SSC is intended for off-road
driving in
4WD Low only. SSC maintains vehicle
speed by actively controlling engine
torque and brakes.
SSC has three states:
Off (feature is not enabled and will not
activate)
Enabled (feature is enabled and ready but
activation conditions are not met, or driver
is actively overriding with brake or throttle
application)
Active (feature is enabled and actively
controlling vehicle speed)
Enabling SSC
SSC is enabled by pushing the SSC switch, but
the following conditions must also be met to
enable SSC:
The driveline is in 4WD Low...
Remove both front panels.
Open both front doors.
Using the provided #50 Torx head driver
and ratchet, remove the two Torx head
screws that secure the hard top at the
B-pillar (near the top of the front doors).
Step Three
Remove the six Torx head screws that
secure the hard top to the vehicle (along the
interior bodyside — three screws on each
side) using the #50 Torx head driver...