Jeep Wrangler: Off-Road Driving Tips / When To Use 4WD Low Range
When off-road driving, shift into 4WD Low for additional traction and control on slippery or difficult terrain, ascending or descending steep hills, and to increase low speed pulling power. This range should be limited to extreme situations such as deep snow, mud, steep inclines, or sand where additional low speed pulling power is needed. Vehicle speeds in excess of 25 mph (40 km/h) should be avoided when in 4WD Low.
CAUTION!
Do not use 4WD Low when operating the vehicle on dry pavement. Driveline hardware damage can result.
Simultaneous Brake And Throttle Operation
Many off-road driving conditions require the simultaneous use of the brake and throttle (two-footed driving). When climbing rocks, logs, or other stepped objects, using light brake pressure with light throttle will keep the vehicle from jerking or lurching. This technique is also used when you need to stop and restart a vehicle on a steep incline.
The Basics Of Off-Road Driving
You will encounter many types of terrain driving
off-road. You should be familiar with the terrain
and area before proceeding. There are many
types of surface conditions: hard-packed dirt,
gravel, rocks, grass, sand, mud, snow and ice...
Driving In Snow, Mud And Sand
Snow
In heavy snow or for additional control and
traction at slower speeds, shift the transmission
into a low gear and the transfer case into 4WD
Low if necessary...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Normal Starting
Observe the instrument cluster lights when starting the engine. NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal. Always apply the parking brake. Press and hold the brake pedal while pushing the ENGINE START/STOP button once...
Jeep Wrangler 2018-2026 Owners Manual: Towing Requirements — Trailer Lights And Wiring
Whenever you pull a trailer, regardless of the trailer size, stoplights and turn signals on the trailer are required for motoring safety. The Trailer Tow Package may include a four- and seven-pin wiring harness. Use a factory approved trailer harness and connector...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- WARNING LIGHTS AND MESSAGES
- How To Use Remote Start
- SOS Call System Limitations
- New on site
- Most important about car
Erasing All The HomeLink® Channels
To erase the channels, follow this procedure:
Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.NOTE:
Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.
