Jeep Wrangler: Apple CarPlay® / Phone
With Apple CarPlay®, push and
hold
the VR button on the steering wheel to
activate a Siri voice recognition
session. You can also press and hold
the Home button within Apple CarPlay® to start
talking to Siri. This allows you to make calls or
listen to voicemail as you normally would using
Siri on your iPhone®.
NOTE:
Only temporarily pushing the VR button on the steering wheel launches a built-in Uconnect VR session, not a Siri session, and it will not function with Apple CarPlay®
Apple CarPlay®
Use this QR code to access your
digital experience.
Uconnect works seamlessly
with Apple CarPlay®, the
smarter, more secure way to
use your iPhone® in the car,
and stay focused on the road...
Music
Apple CarPlay® allows you to
access
all your artists, playlists, and music
from iTunes® or any third party
application installed on your device...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Removing The Hard Top
Remove both front panels. Open both front doors. Using the provided #50 Torx head driver and ratchet, remove the two Torx head screws that secure the hard top at the B-pillar (near the top of the front doors). Step Three Remove the six Torx head screws that secure the hard top to the vehicle (along the interior bodyside — three screws on each side) using the #50 Torx head driver...
Jeep Wrangler 2018-2026 Owners Manual: Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the windshield periodically with a sponge or soft cloth and a mild nonabrasive cleaner. This will remove accumulations of salt or road film. Operation of the wipers on dry glass for long periods may cause deterioration of the wiper blades...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Manual Front Seat Recline Adjustment
- WARNING LIGHTS AND MESSAGES
- Manual Seat Height Adjustment
- New on site
- Most important about car
Turn Signals. Lane Change Assist — If Equipped
Turn Signals
Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.
