Jeep Wrangler: PARKSENSE REAR PARK ASSIST — IF EQUIPPED / ParkSense Warning Display
The ParkSense Warning screen is located within
the instrument cluster display. It
provides visual warnings to indicate the
distance between the rear fascia/bumper and
the detected obstacle.
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the
vehicle that is within the sensors’ field of view.
The sensors can detect obstacles from
approximately 12 inches (30 cm) up to
79 inches (200 cm) from the rear fascia/
bumper in the horizontal direction, depending
on the location, type and orientation of the
obstacle...
When the vehicle is in REVERSE, the instrument
cluster display will show the park assist ready
system status.
The system will indicate a detected obstacle by
showing a single arc in one or more regions
based on the obstacle’s distance and location
relative to the vehicle...
Other information:
Do not interconnect the hydraulic brake
system or vacuum system of your vehicle
with that of the trailer. This could cause inadequate
braking and possible personal injury.
An electronically actuated trailer brake
controller is required when towing a trailer
with electronically actuated brakes...
Before completing the steps below:
If your vehicle is equipped with a Soft
Top, the top MUST be lowered, and the
door rails must be removed prior to
lowering the windshield.
If your vehicle is equipped with a Hard
Top, the Freedom Panels MUST be
removed prior to lowering the windshield...