Jeep Wrangler: Child Restraints / Locating The Upper Tether Anchorages
Two-Door Models:
There are tether strap
anchorages
behind each rear seating position
located on the back of the seat, near
the floor.
Tether Strap Anchorages (Two-Door Models)
Four-Door Models:
There are tether strap anchorages behind each rear seating position located on the back of the seat.
Tether Strap Anchorages (Four-Door Models)
LATCH-compatible child restraint systems will be equipped with a rigid bar or a flexible strap on each side. Each will have a hook or connector to attach to the lower anchorage and a way to tighten the connection to the anchorage. Forward-facing child restraints and some rear-facing child restraints will also be equipped with a tether strap. The tether strap will have a hook at the end to attach to the top tether anchorage and a way to tighten the strap after it is attached to the anchorage.
Locating The LATCH Anchorages
The lower anchorages are round
bars
that are found at the rear of the seat
cushion where it meets the seatback.
They are just visible when you lean
into the rear seat to install the child restraint...
Center Seat LATCH
Two-Door Models:
WARNING!
This vehicle does not have a center seating
position. Do not use the center lower LATCH
anchorages to install a child seat in the
center of the back seat...
Other information:
Jeep Wrangler 2018-2025 Owners Manual: To Manually Turn Off and Turn On The Stop/Start System
TO MANUALLY TURN OFF THE STOP/START SYSTEM Stop/Start OFF Switch Push the Stop/Start OFF switch (located on the switch bank). The light on the switch will illuminate. The “Stop/Start OFF” message will appear in instrument cluster display within the Stop/Start section, and the autostop function will be disabled...
Jeep Wrangler 2018-2025 Owners Manual: Disconnecting The Jumper Cables
Disconnect the negative (-) end of the jumper cable from the engine ground of the vehicle with the discharged battery. Disconnect the opposite end of the negative (-) jumper cable from the negative (-) post of the booster battery. Disconnect the positive (+) end of the jumper cable from the positive (+) post of the booster battery...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Draining Fuel/Water Separator Filter — Diesel Engine
- Display Warnings And Maintenance
- Engine Coolant Level — 2.0L
- New on site
- Most important about car
Automatic Headlights — If Equipped, Lights-On Reminder
Automatic Headlights
This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, rotate the headlight switch clockwise to the last detent for automatic headlight operation. When the system is on, the headlight time delay feature is also on. This means the headlights will stay on for up to 90 seconds after you place the ignition into the OFF position. To turn the automatic system off, move the headlight switch out of the AUTO position.
