Jeep Wrangler: Child Restraints / Locating The LATCH Anchorages
The lower anchorages are round
bars
that are found at the rear of the seat
cushion where it meets the seatback.
They are just visible when you lean
into the rear seat to install the child restraint.
You will easily feel them if you run your finger
along the gap between the seatback and seat
cushion. If your vehicle is equipped with
anchorage symbols on the seatback, they will
be located just above the lower anchorages.

LATCH Anchorages (Two-Door Models)

LATCH Anchorages (Four-Door Models)
LATCH Positions (Two-Door Models)
Lower Anchorage Symbol (2
Anchorages Per Seating Position)
Top Tether Anchorage Symbol
LATCH Positions (Four-Door Models)
Lower Anchorage Symbol (2
Anchorages Per Seating Position)
Top Tether Anchorage Symbol
NOTE:
If the folding, non-adjustable head restraint
interferes with the installation of the child
restraint, the head restraint may be folded and
the child seat installed in front of it (Two-Door
Models)...
Two-Door Models:
There are tether strap
anchorages
behind each rear seating position
located on the back of the seat, near
the floor.
Tether Strap Anchorages (Two-Door Models)
Four-Door Models:
There are tether strap anchorages behind each
rear seating position located on the back of the
seat...
Other information:
NOTE:
Using a fuel filter that does not meet the manufacturer’s
filtration and water separating
requirements can severely impact fuel system
life and reliability. We recommend you use
Mopar® Fuel Filter. Must meet 3 micron rating.
CAUTION!
Diesel fuel will damage blacktop paving
surfaces...
The coolant bottle provides a quick visual
method for determining that the coolant level is
adequate. With the engine OFF and cold, the
level of the engine coolant (antifreeze) in the
bottle should be between the ranges indicated
on the bottle.
The radiator normally remains completely full,
so there is no need to remove the radiator/
coolant pressure cap unless checking for
engine coolant freeze point or replacing
coolant...