Jeep Wrangler 2018-2026 Owners Manual / MULTIMEDIA / CONNECTED VEHICLE SERVICES — IF EQUIPPED / Is My Vehicle Connected?
Jeep Wrangler: CONNECTED VEHICLE SERVICES — IF EQUIPPED / Is My Vehicle Connected?
Vehicles with an Assist and an SOS button are connected vehicles. These buttons will be located on either the rearview mirror or overhead console, depending on the vehicle. If these buttons are present in your vehicle, you have a connected radio and can take advantage of the many connected vehicle features.
For further information about the ASSIST and SOS buttons.
Introduction To Connected Vehicle Services
One of the many benefits of your vehicle’s
Uconnect system is that you can now take
advantage of SiriusXM Guardian™ connected
vehicle services. To unlock the full potential of
SiriusXM Guardian™ in your vehicle, you first
need to activate SiriusXM Guardian™ services...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic brake systems. If either of the two hydraulic systems loses normal capability, the remaining system will still function. However, there will be some loss of overall braking effectiveness. You may notice increased pedal travel during application, greater pedal force required to slow or stop, and potential activation of the Brake Warning Light...
Jeep Wrangler 2018-2026 Owners Manual: LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they are replaced as an assembly. Rear Tail, Stop, Turn Signal, And Backup Lamp See below steps to replace: Remove interior trim panel cap to access single retaining screw for tail lamp assembly. Trim Cap Remove retaining screw and disconnect electrical connector, then remove tail lamp assembly from the vehicle...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- 2.0L Engine and 3.6L Engine
- SERVICING AND MAINTENANCE
- Auxiliary Switches — If Equipped
- New on site
- Most important about car
Turn Signals. Lane Change Assist — If Equipped
Turn Signals
Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.
Copyright © 2026 www.jewrangler.com