Jeep Wrangler: WRANGLER TOPS / Hard Top Front Panel(s) Installation
- Open the header latch inside the vehicle,
and the three L-shaped locks on each
panel.
- Set the right side panel on the windshield
frame with the locating pin in the front
receiver mounting hole followed by the left
side panel, making sure there is no
overhang. Also, make sure that the panels
are sitting flush with the body.
- Reinstall the panel(s) using the same steps
for removal in reverse order.
NOTE:
To prevent water leaks, the seals and hard top
panels should be clear of any dust and debris
prior to reinstallation.
The Freedom Top panels storage bag allows you
to store your hard top panels. The storage bag
contains two compartments.
Lay the bag for the Freedom Top panels down
so the loops and hooks are facing upward...
Remove both front panels.
Open both front doors.
Using the provided #50 Torx head driver
and ratchet, remove the two Torx head
screws that secure the hard top at the
B-pillar (near the top of the front doors)...
Other information:
Can someone else locate my vehicle? Your
vehicle may be located by anyone who has
your PIN and access to your account. It is
your responsibility to guard your PIN
accordingly. See the Uconnect and
SiriusXM Guardian™ terms of service for
more information...
Clean the rubber edges of the wiper blades and
the windshield periodically with a sponge or soft
cloth and a mild nonabrasive cleaner. This will
remove accumulations of salt or road film.
Operation of the wipers on dry glass for long
periods may cause deterioration of the wiper
blades...