Jeep Wrangler 2018-2024 Owners Manual / SAFETY / AUXILIARY DRIVING SYSTEMS / Blind Spot Monitoring (BSM) — If Equipped / Entering From The Rear

Jeep Wrangler: Blind Spot Monitoring (BSM) — If Equipped / Entering From The Rear

Vehicles that come up from behind your vehicle on either side and enter the rear detection zone with a relative speed of less than 30 mph (48 km/h).

Jeep Wrangler. Entering From The Rear

Rear Monitoring

Overtaking Traffic

If you pass another vehicle slowly with a relative speed less than 15 mph (24 km/h) and the vehicle remains in the blind spot for approximately 1.5 seconds, the warning light will be illuminated...

Other information:

Jeep Wrangler 2018-2024 Owners Manual: How To Disengage The Automatic Locking Mode

Unbuckle the combination lap/shoulder belt and allow it to retract completely to disengage the Automatic Locking Mode and activate the vehicle sensitive (emergency) locking mode. WARNING! The seat belt assembly must be replaced if the switchable Automatic Locking Retractor (ALR) feature or any other seat belt function is not working properly when checked according to the procedures in the Service Manual...

Jeep Wrangler 2018-2024 Owners Manual: Closing The Hood

If applicable, refer to the “Hybrid Supplement” for additional information. To close the hood, remove the support rod from the slot and replace it on the hood panel retaining clip. Lower the hood slowly. Secure both of the hood latches. WARNING! Be sure the hood is fully latched before driving your vehicle...

Bi-Level Mode

Jeep Wrangler. Bi-Level Mode Air comes from the instrument panel outlets and floor outlets. A slight amount of air is directed through the defrost and side window demister outlets.

NOTE:

Bi-Level mode is designed under comfort conditions to provide cooler air out of the panel outlets and warmer air from the floor outlets.