Jeep Wrangler: SAFETY FEATURES / Electronic Brake Control (EBC) System
If applicable, refer to the “Hybrid Supplement” for additional information.
Your vehicle is equipped with an advanced Electronic Brake Control (EBC) system. This system includes Anti-Lock Brake System (ABS), Brake Assist System (BAS), Electronic Brake Force Distribution (EBD), Electronic Roll Mitigation (ERM), Electronic Stability Control (ESC), Hill Start Assist (HSA), and Traction Control System (TCS). These systems work together to enhance both vehicle stability and control in various driving conditions.
Your vehicle may also be equipped with Hill Descent Control (HDC), Rain Brake Support (RBS), Ready Alert Braking (RAB), and Trailer Sway Control (TSC).
- Brake System Warning Light
- Brake Assist System (BAS)
- Electronic Brake Force Distribution (EBD)
- Electronic Roll Mitigation (ERM)
Anti-Lock Brake System (ABS)
The ABS provides increased vehicle stability
and brake performance under most braking
conditions. The system automatically prevents
wheel lock, and enhances vehicle control during
braking...
Brake System Warning Light
The red Brake System Warning Light will turn on
when the ignition is placed in the ON/RUN
mode and may stay on for as long as four
seconds.
If the Brake System Warning Light remains on or
comes on while driving, it indicates that the
brake system is not functioning properly and
that immediate service is required...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Stopping The Engine
After full load operation, idle the engine for a few minutes before shutting it down. This idle period will allow the lubricating oil and coolant to carry excess heat away from the turbocharger. NOTE: Refer to the following chart for proper engine shutdown...
Jeep Wrangler 2018-2026 Owners Manual: Auxiliary Switches — If Equipped
Four auxiliary switches located in the lower switch bank of the instrument panel can be used to power various electrical devices. You have the ability to configure the functionality of the auxiliary switches via the Uconnect Settings. All switches can be configured as follows: Switch type operation: Latching or Momentary Power source: Battery or Ignition Ability to hold last state across key cycles: On or Off Auxiliary Switches NOTE: Holding last state conditions are met when switch type is set to latching and power source is set to ignition...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Programming HomeLink® To A Garage Door Opener
- WARNING LIGHTS AND MESSAGES
- SiriusXM® Satellite Radio Mode — If Equipped
- New on site
- Most important about car
Remote Start system
This system uses the key fob to
start
the engine conveniently from outside
the vehicle while still maintaining
security. The system has a range of
approximately 300 ft (91 m).
