Jeep Wrangler: Tire Safety Information / Tire Sizing Chart

Jeep Wrangler. Tire Sizing Chart

Jeep Wrangler. Tire Sizing Chart

    Tire Markings

    Tire Markings US DOT Safety Standards Code (TIN) Size Designation Service Description Maximum Load Maximum Pressure Treadwear, Traction and Temperature Grades NOTE: P (Passenger) — Metric tire sizing is based on US design standards...

    Tire Identification Number (TIN)

    The Tire Identification Number (TIN) may be found on one or both sides of the tire; however, the date code may only be on one side. Tires with white sidewalls will have the full TIN, including the date code, located on the white sidewall side of the tire...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Locating The LATCH Anchorages


    The lower anchorages are round bars that are found at the rear of the seat cushion where it meets the seatback. They are just visible when you lean into the rear seat to install the child restraint. You will easily feel them if you run your finger along the gap between the seatback and seat cushion...

    Jeep Wrangler 2018-2026 Owners Manual: Front/Rear Axle Fluid


    For normal service, periodic fluid level checks are not required. When the vehicle is serviced for other reasons the exterior surfaces of the axle assembly should be inspected. If gear oil leakage is suspected inspect the fluid level. Fluid Level Check Lubricant should be approximately 1/8 inch (3 mm) below the bottom edge of the oil fill hole...

    Categories

    Erasing All The HomeLink® Channels

    To erase the channels, follow this procedure:

    Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

    NOTE:

    Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

    read more

     
    Copyright © 2026 www.jewrangler.com