Jeep Wrangler: Tires — General Information / Tire Repair
If your tire becomes damaged, it may be repaired if it meets the following criteria:
- The tire has not been driven on when flat.
- The damage is only on the tread section of your tire (sidewall damage is not repairable).
- The puncture is no greater than a . of an inch (6 mm).
Consult an authorized tire dealer for tire repairs and additional information.
Damaged Run Flat tires, or Run Flat tires that have experienced a loss of pressure should be replaced immediately with another Run Flat tire of identical size and service description (Load Index and Speed Symbol). Replace the tire pressure sensor as well as it is not designed to be reused.
Radial Ply Tires
WARNING!
Combining radial ply tires with other types of
tires on your vehicle will cause your vehicle to
handle poorly. The instability could cause a collision...
Run Flat Tires — If Equipped
Run Flat tires allow you the capability to drive
50 miles (80 km) at 50 mph (80 km/h) after a
rapid loss of inflation pressure. This rapid loss
of inflation is referred to as the Run Flat mode...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Installing The Hard Top
If the door frames are installed from soft top usage, they must be removed prior to installation of the hard top. For removal procedures. To install the hard top, place the hard top on the vehicle while making sure that the top is sitting flush with the body at the sides and check to ensure that there is a uniform gap between the lift glass and hard top...
Jeep Wrangler 2018-2026 Owners Manual: Instrument Cluster Descriptions
Tachometer Indicates the engine speed in revolutions per minute (RPM x 1000). CAUTION! Do not operate the engine with the tachometer pointer in the red area. Engine damage will occur. Temperature Gauge The temperature gauge shows engine coolant temperature...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Jack Location
- Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass
- Display Warnings And Maintenance
- New on site
- Most important about car
Manual Front Seat Forward/Rearward Adjustment
The seat can be adjusted forward or rearward by using a bar located by the front of the seat cushion, near the floor. While sitting in the seat, lift up on the bar located under the seat cushion and move the seat forward or rearward. Release the bar once you have reached the desired position. Then, using body pressure, move forward and rearward on the seat to be sure that the seat adjusters have latched.
Adjustment Bar Location
