Jeep Wrangler: UCONNECT MODES / Steering Wheel Audio Controls

The remote sound system controls are located on the rear surface of the steering wheel at the three and nine o’clock positions.

Jeep Wrangler. Steering Wheel Audio Controls

Remote Sound System Controls

The right-hand control is a rocker-type switch with a push button in the center and controls the volume and mode of the sound system. Pushing the top of the rocker switch will increase the volume, and pushing the bottom of the rocker switch will decrease the volume.

Pushing the center button will make the radio switch between the various modes available (AM/FM/SXM or Media, etc.).

The left-hand control is a rocker-type switch with a push button in the center. The function of the left-hand control is different depending on which mode you are in.

The following describes the left-hand control operation in each mode:

Radio Operation

Pushing the top of the switch will Seek Up for the next available station and pushing the bottom of the switch will Seek Down for the next available station.

The button located in the center of the left-hand control will tune to the next preset station that you have programmed in the radio presets.

Media Mode

Pushing the top of the switch skips to the next track on the selected media (AUX/USB/ Bluetooth®). Pushing the switch up twice will go forward two tracks. Pushing the bottom switch goes to the beginning of the current track, or the beginning of the previous track if it is within eight seconds after the current track begins to play. Double pressing the bottom button switch will skip to the previous track if it is after eight seconds into the current track.

    UCONNECT MODES

    ..

    Radio Mode

    ..

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Cargo Carpet (Four Door Models)


    Remove the grommets under the rear seat (one left and one right). Pull the carpet out to the rear and open the carpet split around the seat belt attachment. Under Rear Seat Carpet Split Rear Carpet Remove the carpet under the load floor and the side support and then pull the carpet out...

    Jeep Wrangler 2018-2026 Owners Manual: Auxiliary Switches — If Equipped


    Four auxiliary switches located in the lower switch bank of the instrument panel can be used to power various electrical devices. You have the ability to configure the functionality of the auxiliary switches via the Uconnect Settings. All switches can be configured as follows: Switch type operation: Latching or Momentary Power source: Battery or Ignition Ability to hold last state across key cycles: On or Off Auxiliary Switches NOTE: Holding last state conditions are met when switch type is set to latching and power source is set to ignition...

    Categories

    REMOTE START — IF EQUIPPED (DIESEL)

    read more

     
    Copyright © 2026 www.jewrangler.com