Jeep Wrangler 2018-2026 Owners Manual / SERVICING AND MAINTENANCE / TIRES / Spare Tires — If Equipped / Spare Tire Matching Original Equipped Tire And Wheel — If Equipped

Jeep Wrangler: Spare Tires — If Equipped / Spare Tire Matching Original Equipped Tire And Wheel — If Equipped

Your vehicle may be equipped with a spare tire and wheel equivalent in look and function to the original equipment tire and wheel found on the front or rear axle of your vehicle. This spare tire may be used in the tire rotation for your vehicle.

If your vehicle has this option, refer to an authorized tire dealer for the recommended tire rotation pattern.

Spare Tires — If Equipped

NOTE: For vehicles equipped with Tire Service Kit instead of a spare tire, please refer to “Tire Service Kit” in “In Case Of Emergency” for further information...

Compact Spare Tire — If Equipped

The compact spare is for temporary emergency use only. You can identify if your vehicle is equipped with a compact spare by looking at the spare tire description on the Tire and Loading Information Placard located on the driver’s side door opening or on the sidewall of the tire...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Redundant Air Bag Warning Light

If a fault with the Air Bag Warning Light is detected, which could affect the Supplemental Restraint System (SRS), the Redundant Air Bag Warning Light will illuminate on the instrument panel. The Redundant Air Bag Warning Light will stay on until the fault is cleared...

Jeep Wrangler 2018-2026 Owners Manual: Lowering The Soft Top All The Way

Remove the rear window and quarter panel windows. From the Sunrider® position, remove straps if previously secured and move to the rear of the vehicle. Locate the Sunrider® latch beneath the #6 Bow of the soft top on the left side. Step Three Pull the latch to release the top, and allow the soft top to slide rearward freely in the guide tracks to the stowed position...

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.