Jeep Wrangler: DOOR FRAME / Door Frame Installation Two Door Models — If Equipped
- Carefully place the front door rail in the
rubber seal at the top of the windshield,
and line up the holes for the Torx head
screws (two for each door).
- Swing the frame bracket around the side of
the rail, and insert the screws from
underneath. Tighten with #40 Torx head
driver until they are snug, being careful not
to cross-thread the screws or overtighten.
Refer to the table below for the appropriate
torque specifications for the door rail
screws.

Step Two

CAUTION!
Do not overtighten the screws. You can strip
the screws if they are overtightened.
Install the front door rail first.
Carefully place the front door rail in the
rubber seal at the top of the windshield, and
line up the holes for the Torx head screws
(two for each door)...
CAUTION!
Lowering of the windshield is NOT
recommended in vehicles equipped with a
Power Sliding Top. Damage will occur to the
top as well as the header seal...
Other information:
For the proper maintenance intervals
NOTE:
Be sure to follow the “Severe Duty Conditions”
maintenance interval if applicable.
WARNING!
The air induction system (air cleaner, hoses,
etc.) can provide a measure of protection in
the case of engine backfire...
The Media Hub is located on the instrument
panel, below the climate controls. Behind the
media hub access door, the Media Hub
contains one AUX port, a Type C USB port and
one standard USB port. Both USB ports allow
you to play music from MP3 players /
smartphones or USB devices through the
vehicle’s sound system...