Jeep Wrangler 2018-2025 Owners Manual / GETTING TO KNOW YOUR VEHICLE / MIRRORS / Inside Rearview Mirror / Automatic Dimming Mirror — If Equipped

Jeep Wrangler: Inside Rearview Mirror / Automatic Dimming Mirror — If Equipped

The rearview mirror can be adjusted up, down, left, and right. The mirror should be adjusted to center on the view through the rear window.

The mirror automatically adjusts to headlight glare from vehicles behind you.

NOTE:

The Automatic Dimming feature is disabled when the vehicle is in REVERSE to improve the driver’s view.

Jeep Wrangler. Automatic Dimming Mirror — If Equipped

Automatic Dimming Mirror

The Automatic Dimming feature can be turned on or off through Uconnect Settings.

CAUTION!

To avoid damage to the mirror during cleaning, never spray any cleaning solution directly onto the mirror. Apply the solution onto a clean cloth and wipe the mirror clean.

Manual Mirror — If Equipped

The rearview mirror can be adjusted up, down, left, and right. The mirror should be adjusted to center on the view through the rear window. Headlight glare from vehicles behind you can be reduced by moving the small control under the mirror to the night position (toward the rear of the vehicle)...

Illuminated Vanity Mirrors

T..

Other information:

Jeep Wrangler 2018-2025 Owners Manual: Life Of Tire

The service life of a tire is dependent upon varying factors including, but not limited to: Driving style. Tire pressure - Improper cold tire inflation pressures can cause uneven wear patterns to develop across the tire tread. These abnormal wear patterns will reduce tread life, resulting in the need for earlier tire replacement...

Jeep Wrangler 2018-2025 Owners Manual: Removing The Hard Top

Remove both front panels. Open both front doors. Using the provided #50 Torx head driver and ratchet, remove the two Torx head screws that secure the hard top at the B-pillar (near the top of the front doors). Step Three Remove the six Torx head screws that secure the hard top to the vehicle (along the interior bodyside — three screws on each side) using the #50 Torx head driver...