Jeep Wrangler: Media Mode / Audio Source Selection
Once in Media Mode, press the Source or
Source Select button on the touchscreen and
the desired mode button on the touchscreen.
USB, AUX, and Bluetooth® are the Media
sources available. When available, you can select the Browse button on the
touchscreen to
be given these options:
- Now Playing
- Artists
- Albums
- Genres
- Songs
- Playlists
- Folders
You can press the Source, Pause/Play, or the
Info button on the touchscreen for artist
information on the current song playing.
For the Uconnect 3 With 5-inch Display, Media
Mode is entered by pushing the Media button
located on the faceplate.
Uconnect 3 With 5-inch Display Operating Media Mode
Seek Down
Seek Up
Browse
Source
Pause/Play
Info
More Options
Media Mode is entered by pushing the MEDIA
button located on the faceplate...
USB Mode
Overview
USB Mode is entered by either inserting a USB
device into the USB port, or by selecting the USB
button on the left side of the touchscreen, or the
Source Select/Select Source button and then
selecting USB 1 or 2 (if equipped) or by pushing
the MEDIA button on the faceplate and then
selecting the USB button...
Other information:
Four auxiliary switches located in the lower
switch bank of the instrument panel can be
used to power various electrical devices. You
have the ability to configure the functionality of
the auxiliary switches via the Uconnect Settings.
All switches can be configured as follows:
Switch type operation: Latching or Momentary
Power source: Battery or Ignition
Ability to hold last state across key cycles: On or Off
Auxiliary Switches
NOTE:
Holding last state conditions are met when
switch type is set to latching and power source
is set to ignition...
Push down on the release bar on each
side, and pull the seat out and away from
the lower bracket.
Release Bar Location
Remove the seat from the vehicle.
To reinstall the rear seat, just reverse these
steps.
NOTE:
Do not drive the vehicle without reattaching the
rear seat latches...