Jeep Wrangler: Yellow Indicator Lights / 4WD Indicator Light — If Equipped

Jeep Wrangler. 4WD Indicator Light — If Equipped This light alerts the driver that the vehicle is in the four-wheel drive mode, and the front and rear driveshafts are mechanically locked together forcing the front and rear wheels to rotate at the same speed.

    Yellow Indicator Lights

    ..

    4WD Low Indicator Light — If Equipped

    This light alerts the driver that the vehicle is in the four-wheel drive LOW mode. The front and rear driveshafts are mechanically locked together forcing the front and rear wheels to rotate at the same speed...

    Other information:

    Jeep Wrangler 2018-2025 Owners Manual: Stopping The Engine


    After full load operation, idle the engine for a few minutes before shutting it down. This idle period will allow the lubricating oil and coolant to carry excess heat away from the turbocharger. NOTE: Refer to the following chart for proper engine shutdown...

    Jeep Wrangler 2018-2025 Owners Manual: Front/Rear Axle Fluid


    For normal service, periodic fluid level checks are not required. When the vehicle is serviced for other reasons the exterior surfaces of the axle assembly should be inspected. If gear oil leakage is suspected inspect the fluid level. Fluid Level Check Lubricant should be approximately 1/8 inch (3 mm) below the bottom edge of the oil fill hole...

    Categories

    Automatic Headlights — If Equipped, Lights-On Reminder

    Automatic Headlights

    This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, rotate the headlight switch clockwise to the last detent for automatic headlight operation. When the system is on, the headlight time delay feature is also on. This means the headlights will stay on for up to 90 seconds after you place the ignition into the OFF position. To turn the automatic system off, move the headlight switch out of the AUTO position.

    read more

     
    Copyright © 2025 www.jewrangler.com