Jeep Wrangler: Power Sliding Top — If Equipped / Quarter Window Storage Bag
To use the storage bags for the rear quarter
windows, proceed as follows:
- With the bag completely open and the
fabric divider raised, place the first quarter
window with the latches facing outward
into the foam insert. Fold divider over the
window once placed inside.

Step One
-
Bag Open With Divider Raised
-
Lower Divider Over Window (Latches Facing
Outward)
- Place the second window into the foam
insert with the latches facing outward. Fully
close the bag.
NOTE:
Once both windows are placed inside the bag,
the outside of the windows will be facing each
other with all latches facing the outside of the
bag.

Step Two
-
Second Window Placed Over Divider
-
Fully Closed Bag
- Store the bag in a safe location, or in the
cargo area of the vehicle by securing the
bag in the vehicle’s cargo area. This is done
by attaching the straps at the top of the bag
to the rear head restraints, as well as
attaching the clip at the bottom of the bag to
the forward most cargo hook on the load
floor.

Step Three
On vehicles equipped with a Power Sliding Top,
the rear quarter windows can be removed. To
remove these windows, follow the procedure
below:
Open the swing gate, and lift the rear
window...
WARNING!
Do not drive your vehicle on public roads
with the door frame(s) removed as you will
lose the protection that they can provide.
This procedure is furnished for use during
off-road operation only...
Other information:
NOTE:
Depending on the vehicle’s options, feature
settings may vary.
Speedometer
Push and release the up or
down arrow
button until the speedometer menu icon is
displayed in the instrument cluster display.
Push and release the OK button to toggle
between MPH and km/h...
Release the strap that secured the
windshield in the lowered position.
Raise the windshield.
Using the provided #40 Torx head driver,
reinstall the four Torx screws located along
the interior of the windshield. Secure them
until they are snug, being careful not to
cross-thread the screws or overtighten...