Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR VEHICLE / MIRRORS / Outside Mirrors

Jeep Wrangler: MIRRORS / Outside Mirrors

The outside mirror(s) can be adjusted to the center of the adjacent lane of traffic to achieve the optimal view.

Jeep Wrangler. Outside Mirrors

Outside Rearview Mirror

WARNING!

Vehicles and other objects seen in the passenger side convex mirror will look smaller and farther away than they really are. Relying too much on your passenger side mirror could cause you to collide with another vehicle or other object. Use your inside mirror when judging the size or distance of a vehicle seen in the passenger side mirror.

Illuminated Vanity Mirrors

T..

Heated Mirrors and Power Mirrors — If Equipped

Heated Mirrors These mirrors are heated to melt frost or ice. This feature will be activated whenever you turn on the rear window defroster (if equipped)...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: BRAKE SYSTEM

Your vehicle is equipped with dual hydraulic brake systems. If either of the two hydraulic systems loses normal capability, the remaining system will still function. However, there will be some loss of overall braking effectiveness. You may notice increased pedal travel during application, greater pedal force required to slow or stop, and potential activation of the Brake Warning Light...

Jeep Wrangler 2018-2026 Owners Manual: Rolling Code Garage Door Opener Final Steps

NOTE: You have 30 seconds in which to initiate rolling code final step 2, after completing rolling code final step 1. At the garage door opener motor (in the garage), locate the “LEARN” or “TRAIN” button. This can usually be found where the hanging antenna wire is attached to the garage door opener motor...

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.