Jeep Wrangler: UNIVERSAL GARAGE DOOR OPENER (HOMELINK®) — IF EQUIPPED / Identifying Whether You Have A Rolling Code Or Non-Rolling Code Device

Before programming a device to one of your HomeLink® buttons, you must determine whether the device has a rolling code or non-rolling code.

Rolling Code Devices

To determine if your device has a rolling code, a good indicator is its manufacturing date. Typically, devices manufactured after 1995 have rolling codes. A device with a rolling code will also have a “LEARN” or “TRAIN” button located where the antenna is attached to the device. The button may not be immediately visible when looking at the device. The name and color of the button may vary slightly by manufacturer.

NOTE:

The “LEARN” or “TRAIN” button is not the button you normally use to operate the device.

Non-rolling Code Devices

Most devices manufactured before 1995 will not have a rolling code. These devices will also not have a “LEARN” or “TRAIN” button.

    Erasing All The HomeLink® Channels

    To erase the channels, follow this procedure: Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes...

    Programming HomeLink® To A Garage Door Opener

    To program any of the HomeLink® buttons to activate your garage door opener motor, follow the steps below: NOTE: All HomeLink® buttons are programmed using this procedure...

    Other information:

    Jeep Wrangler 2018-2024 Owners Manual: Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass


    Automatic High Beam Headlamp Control The Automatic High Beam Headlamp Control system provides increased forward lighting at night by automatically controlling the high beams through the use of a camera mounted on the vehicle’s header. This camera detects vehicle specific light and automatically switches from high beams to low beams until the approaching vehicle is out of view...

    Jeep Wrangler 2018-2024 Owners Manual: Oil Change Reset — If Equipped


    Your vehicle may be equipped with an engine oil change indicator system. The “Oil Change Required” message will display in the instrument cluster display for five seconds after a single chime has sounded to indicate the next scheduled oil change interval...

    Categories

    Remote Start system

    Jeep Wrangler. Remote Start system This system uses the key fob to start the engine conveniently from outside the vehicle while still maintaining security. The system has a range of approximately 300 ft (91 m).

    read more

     
    Copyright © 2024 www.jewrangler.com