Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR VEHICLE / SEATS / Fold And Tumble Rear Seat — Two Door Models

Jeep Wrangler: SEATS / Fold And Tumble Rear Seat — Two Door Models

NOTE:

  • Prior to folding the rear seat, it may be necessary to reposition the front seats.
  • Be sure that the front seats are fully upright and positioned forward. This will allow the rear seat to fold down easily.

60/40 Split Folding Rear Seat — Four Door Models

To provide additional storage area, each rear seat can be folded flat to allow for extended cargo space. NOTE: Be sure that the front seats are fully upright and positioned forward...

Folding The Rear Seat

..

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Lap/Shoulder Belt Untwisting Procedure


Use the following procedure to untwist a twisted lap/shoulder belt. Position the latch plate as close as possible to the anchor point. At about 6 to 12 inches (15 to 30 cm) above the latch plate, grab and twist the seat belt webbing 180 degrees to create a fold that begins immediately above the latch plate...

Jeep Wrangler 2018-2026 Owners Manual: Autostop Mode


WARNING! Vehicles with the Stop/Start system will be equipped with two batteries. Both the main and the supplemental batteries must be disconnected to completely de-energize the 12 Volt electrical system. Serious injury or death could result if you do not disconnect both batteries...

Categories

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

read more

 
Copyright © 2026 www.jewrangler.com